Product description

The magnetic force is generated by the permanent magnets which are magnetised and demagnetised with short current pulses. The block magnet features a sturdy design and a long service life. The pole pitch forms “true” N and S poles.

With continuous transverse pole pitch P = 13 mm, 18 mm and 25 mm

DESIGN
ƒ- Solid pole plate with 13 mm, 18 mm or 25 mm transverse pole pitch
ƒ- “True” N/S pole spacing
ƒ- Switch-off using demagnetising cycle
ƒ- Electro permanent magnetic system for absolute safety in case of power failure.
-ƒ On request available with compressed air holes for P = 18/25 mm for easier removal of larger parts (adhesion)
-ƒ High accuracy thanks to pole plates bolted in a narrow grid
-ƒ Reinforced systems for high wear possible on request ƒ 8 mm wear layer on the pole plate
ƒ- Pole plate can be replaced when worn
ƒ- Chucking slots on both face sides
-ƒ Length over 1000 mm with through holes for fastening upon agreement or machine table
-ƒ Robust and water-tight
ƒ- Protection rating IP 65

RATED HOLDING FORCE
90 N/cm2, with P = 13 mm pole pitch
110 N/cm2, with P = 18 mm pole pitch
115 N/cm2, with P = 25 mm pole pitch
Controllable with control unit.

RATED VOLTAGE, RECOMMENDED
210 V IMP up to size A x B = 600 x 400
360 V IMP above size A x B = 600 x 40

APPLICATION
- For universal chucking of workpieces with high precision.
ƒ- For main workpiece axis perpendicular to thepole pitch.

ƒFor workpieces up to min. thickness x:
4.5 mm with P = 13 mm
6.0 mm with P = 18 mm
8.5 mm with P = 25 mm

ƒ For flat workpieces min. a:
25 mm x 25 mm with P = 13 mm
32 mm x 32 mm with P = 18 mm
45 mm x 45 mm with P = 25 mm

SCOPE OF DELIVERY
ƒ- Stop bar on one short and one long side
ƒ- 3 m connecting cable on right short side, rear
ƒ- On request with water-tight heavy-duty power connector
ƒ- Larger magnetic chucks from 25 kg are provided with lifting lugs for transport
ƒ- Control and hand remote unit not in the scope of delivery
ƒ- Clamps